Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Assemble steppers to base corner brackets
[* black] Gather the parts for this step.
[* orange] Three ''base corner brackets'' are the larger set of brackets in box '''(B)'''(box B). The smaller set are the ''top corner brackets''.
[* orange] Three ''stepper motors'' from box '''(C)'''C.
[* orange] Remove the following parts from the bag labeled ''Motion MagBall'' in box '''(C)'''C. The parts are listed on the bag label.
[* orange] Three ''base corner brackets'' are the larger set of brackets in box '''(B)'''(box B). The smaller set are the ''top corner brackets''.
[* orange] Three ''stepper motors'' from box '''(C)'''C.
[* orange] Remove the following parts from the bag labeled ''Motion MagBall'' in box '''(C)'''C. The parts are listed on the bag label.
[* orange] Twelve ''M3x8 SHCS - Motors''.
[* orange] Three ''GT2 16 Tooth Pulleys''.
[* black] ++Loosely++ attach a ''pulley'' to each of the stepper motor shafts using a 1.5mm Allen wrench. The thin flange should face away from the stepper as shown in the photo. One of the set screws should align with the flat on the stepper motor shaft as shown.
[* black] Orient the wiring coming out of the stepper to face up as shown and attach to the corner bracket using four ''M3x8 SHCS'' screws for each assembly. Use a 2.5mm Allen wrench, a ball head Allen wrench makes this a lot easier.