Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #7

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Assemble steppers to base corner brackets
[* black] PlaceGather the pulley onparts for this step.
[* orange] Three ''base corner brackets'' are
the stepper shaft - do not tighten it in place. The thin pulley flange end should face out as you can see inlarger set of brackets.The smaller set are the photo''top corner brackets''.
[* orange] Three ''stepper motors''.
[* orange] The ''NEMA Hardware'' bag
.
[* black] PlaceGather the pulley onparts for this step.
[* orange] Three ''base corner brackets'' are
the stepper shaft - do not tighten it in place. The thin pulley flange end should face out as you can see inlarger set of brackets.The smaller set are the photo''top corner brackets''.
[* orange] Three ''stepper motors''.
[* orange] The ''NEMA Hardware'' bag
.
[* black] Orient the wiring coming out of the stepper to face up as shown and attach to the corner bracket using two screws for each assembly.