Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #22

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Aligning the top
[* red] Push the cross members flat to the table and then ++tighten++ the six screws closest to the table shown in red in the photo.
[* red] ++Tighten++ the six lowerupper screws closest to you shown in blue in the photo.
[* red] ++Tighten++ the six lowerupper screws closest to you shown in blue in the photo.
[* red] Then tighten the six screws nearest you located inside the corner brackets as shown in the second photo..
[* red] Flip the assembly over and tighten the remaining six screws inside the corner brackets.
[* icon_note] Make sure all twenty-four screws are tight.
[* icon_caution] Lay the top on the flat surface with the '''XYZ''' labels facing up and test to see if it rocks or tips. If so, you need to loosen ''all of the screws'' and ''repeat this step'' again! So best to work carefully and get it right the first time.