Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #22

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Aligning the top
[* red] Push the cross members flat to the table and then tighten the six upper and six lower screws you can reach near the stepper motors. Then tighten the six screws inside the corner brackets.
[* red] Flip the assembly over and tighten the other six screws inside the corner brackets.
[* red] Make sure all twenty-four screws are tight. Lay the top assembly on a flat surface with the '''XYZ''' labels facing up and test to see if it rocks or tips. If so, you need to loosen ''all of the screws'' and ''repeat this step'' again! So best to work carefully and get it right the first time.