Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #15

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Aligning he base
[* red] The process is to push all three bottom cross members flat against the table then tighten the six lower screws you can reach near the stepper motors. Once those are tight, remove the cord and carefully flip the base unit over.
[* red] Tighten the six ++upper screws++ located inside the corner brackets. Make sure all twelve top screws are tight. Now push the lower three cross members flat against the table and repeat the previous step: tighten the six screws next to the steppers, flip over, and tighten the remaining six screws inside the corner brackets.
[* red] Make sure all twenty-four screws are tight. Lay the base on a flat surface with the '''XYZ''' labels facing up and test to see if it rocks or tips. If so, you need to loosen ''all of the screws'' and ''repeat this step'' again! So best to work carefully and get it right the first time.