Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #3

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install magball nuts
[* red] Install the two ''M3 nuts'' into the carriage slots. This can be tricky but you can align the nut and then push it in with a small screwdriver.
[* red] Once the nut is in place, use a 2mm Allen wrench to make sure the nut is aligned with the hole in the carriage.
[* red] Install ++only++ the magball on the left side of the carriage as shown. A 10mm socket works well or use a 10mm wrench. Tighten but do not over-tighten the magball.

Image 1

No previous image

Added

Image 2

No previous image

Added