Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Assemble carriagesCarriage preparation
[title] Assemble carriagesCarriage preparation
[* red] Locate three printed carriage bodies in box B and the bag labeled ''Motion MagBall'' from box C.
[* red] Locate the carriage parts bag shown in the photophoto and find the ''OpenBuild wheels'', ''magball'', and ''hardware'' bags shown .
[* icon_caution] Inspect all printed partsthe carriages for loose plastic, burrs and other artifacts. Trim with an X-acto™ knife if necessary. On all printed parts ++except++Do NOT++ clean out the carriages++, check any throughmagball holes to make surewith a drill, they are clean. If not, use an appropriately sized drill bit to clear thembe a tight fit.
[* red] The second photo shows all the parts required to assemble one carriage. You should have three sets of these parts
.
[* red] Locate the carriage parts bag shown in the photophoto and find the ''OpenBuild wheels'', ''magball'', and ''hardware'' bags shown .
[* icon_caution] Inspect all printed partsthe carriages for loose plastic, burrs and other artifacts. Trim with an X-acto™ knife if necessary. On all printed parts ++except++Do NOT++ clean out the carriages++, check any throughmagball holes to make surewith a drill, they are clean. If not, use an appropriately sized drill bit to clear thembe a tight fit.
[* red] The second photo shows all the parts required to assemble one carriage. You should have three sets of these parts
.

Image 1

No previous image

Added

Image 2

No previous image

Added