Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #39

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Install the top on the towers
[* icon_note] The top assembly must be installed with the labels you applied facing up and the '''X''', '''Y''' and '''Z '''corners aligned with the base '''X''', '''Y''' and '''Z''' corners.
[* icon_caution] The idler pulley holes in the top brackets must be closest to the bottom of the frame as indicated in the photo.
[* red] Align the ''T-nuts'' and carefully lower the top assembly onto the towers. "Wiggle and jiggle" the ''T-nuts'' until the top assembly slides over both ''T-nuts'' in each corner bracket.
[* icon_note] It helps to have a helper with this step but it can be done alone if you align the ''T-nuts'' and work slowly.
[* icon_note] The third photo is annotated to show thdthe conventional orientation for delta printers. The '''X''' tower is to the left, '''Y''' to the right and '''Z''' in the center back.
[* icon_note] The third photo is annotated to show thdthe conventional orientation for delta printers. The '''X''' tower is to the left, '''Y''' to the right and '''Z''' in the center back.