Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #28

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Installing the towers in the base
[* red] Positon the base with the '''X''', '''Y''', '''Z''' labels facing up on a flat surface.
[* red] Align the T-nuts in the '''X''' corner bracket so the tower extrusion slot can slide onto them.
[* red] The end of the tower with the tape-marked threaded hole inserts into the base. The threaded hole should be on the outside edge of the base bracket as shown in the photo.
[* red] Slide the tower extrusion over the T-nuts. Push the tower all the way down to the table. Then tighten the two screws.
[* icon_note] Remove the masking tape marking the threaded hole before inserting the tower in its slot.
[* red] Repeat the previous steps for the '''Y''' and '''Z''' towers.