Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #28

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Installing the towers in the base
[* red] On the same flat surface you assembled the base and upper triangles, positonPositon the base with the '''X''', '''Y''', '''Z''' labels facing upup on a flat surface.
[* red] Align the T-nuts in the X'''X''' corner bracket so the tower extrusion slot can slide onto them.
[* red] The end of the tower with the tape-marked threaded hole inserts into the base. The threaded hole should be on the outside edge of the base bracketbracket as shown in the photo.
[* red] Gently slideSlide the tower extrusion over the T-nuts. Push the tower all the way down.
[* red] Push
down onto the base and the tower to ensure that they are flush, thentable. Then tighten the two screws securelyscrews.
[* red] On the same flat surface you assembled the base and upper triangles, positonPositon the base with the '''X''', '''Y''', '''Z''' labels facing upup on a flat surface.
[* red] Align the T-nuts in the X'''X''' corner bracket so the tower extrusion slot can slide onto them.
[* red] The end of the tower with the tape-marked threaded hole inserts into the base. The threaded hole should be on the outside edge of the base bracketbracket as shown in the photo.
[* red] Gently slideSlide the tower extrusion over the T-nuts. Push the tower all the way down.
[* red] Push
down onto the base and the tower to ensure that they are flush, thentable. Then tighten the two screws securelyscrews.
[* red] Repeat the previous steps for the '''Y''' and '''Z''' towers.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added