Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #20

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Assemble the top triangle
[* red] The top triangle assembles similar to the base triangle but is a little easier since there is only one cross member between corner brackets.
[* red] Lay out the three top assemblies on a flat surface with the labels facing up. Place the '''X''' assembly on your left, the '''Y''' assembly on your right and the '''Z''' assembly opposite you as shown in the first photo.
[* red] Starting with the rails attached to the '''Z''' assembly, slide them onto the '''XY''' assembly T-nuts until the first two T-nuts (one top and one bottom) are just hidden as shown in the second photo.
[* red] Starting with the rails attached to the '''Z''' assembly, slide them onto the '''XY''' assembly T-nuts until the first two T-nuts (one top and one bottom) are just hidden as shown in the second photo.
[* red] Repeat this for the other two sets of rails and corner brackets to form a loose triangle.
[* red] Carefully work clockwise around the top starting with the '''X''' assembly. Push each set of rails about 1cm (1/2") further into the corner bracket and move on to the next. Repeat this several times around until the rails reach the second set of T-nuts.
[* red] Gently and carefully start the exposed T-nuts into their slots – but only push them half way in. Continue working clockwise until all T-nuts are started half way into their slots.
[* icon_note] A small screw driver is handy to align the T-nuts with the slot. This step and the next are also a lot easier with two people to wiggle, jiggle and push the T-nuts into the slots.
[* red] Finally, push all of the rails until they seat against the corner bracket. It helps to++ gently snug++ the twelve outer screws nearest the stepper motors to help hold the assembly together.
[* red] Finally, push all of the rails until they seat against the corner bracket. It helps to++ gently snug++ the twelve outer screws nearest the stepper motors to help hold the assembly together.