Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #89

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] Final Thoughts
[* icon_note] That's it! Your D300VS is assembled and all systems are checked out and operational. You can turn off your hot end heater and read one of the ''First Print'' guides listed below.
[* icon_caution] '''NEVER''' leave your printer unattended when the hot end and bed heaters are on. This also means that you should ++always++ be present when you are printing.
[* red] We recommend positioning your D300VS as shown in the photo with the '''X''' tower to the left, '''Y''' to the right and '''Z''' directly in back. This is the orientation makes it easy to describe when asking for helpthat your slicer will slice your models.
[* red] We recommend positioning your D300VS as shown in the photo with the '''X''' tower to the left, '''Y''' to the right and '''Z''' directly in back. This is the orientation makes it easy to describe when asking for helpthat your slicer will slice your models.
[* icon_note] Next Steps...
[* red] If you plan to print PLA filament for your first print, please read the ''[guide|3]'' guide.
[* red] If you plan to print ABS filament for your first print, please read the ''[guide|5]'' guide.
[* red] You can also look ahead to the ''[guide|6]'' guide, but we do recommend you get several prints under your belt before installing PEI or making any modifications to your printer.