Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #89

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] First printFinal Thoughts
[* red] Install a spool of PLA or ABS filament on the spool holder as shown in theicon_note] That's it! Your D300VS is assembled and all systems are checked out and operational. You are ready to make your first photo. Make sure the spool can rotate freely.
[* red]
print. If you took a break afterare ready to do that now, proceed to the previousnext step, heatotherwise, turn off the hot end heater.
[* icon_caution] '''NEVER''' leave
your printer unattended when the hot end to 195°C for PLA or 220°C for ABS and allow it to come up to temperature and stabilize for a few minutesbed heaters are on. This also means that you should ++always++ be present when you are printing.
[title] First printFinal Thoughts
[* red] Install a spool of PLA or ABS filament on the spool holder as shown in theicon_note] That's it! Your D300VS is assembled and all systems are checked out and operational. You are ready to make your first photo. Make sure the spool can rotate freely.
[* red]
print. If you took a break afterare ready to do that now, proceed to the previousnext step, heatotherwise, turn off the hot end heater.
[* icon_caution] '''NEVER''' leave
your printer unattended when the hot end to 195°C for PLA or 220°C for ABS and allow it to come up to temperature and stabilize for a few minutesbed heaters are on. This also means that you should ++always++ be present when you are printing.