Skip to main content

Site Navigation

Your Account

Choose Language

Changes to Step #89

Edit by Michael Hackney

Edit approved by Michael Hackney

Deleted
Added
Unchanged

Step Lines

[title] CommissioningFirst print
[* red] Install a spool of PLA or ABS filament on
the extruderspool holder as shown in the first photo. Make sure the spool can rotate freely.
[* red] Insert wisdom hereIf you took a break after the previous step, heat your hot end to 195°C for PLA or 220°C for ABS and allow it to come up to temperature and stabilize for a few minutes.
[title] CommissioningFirst print
[* red] Install a spool of PLA or ABS filament on
the extruderspool holder as shown in the first photo. Make sure the spool can rotate freely.
[* red] Insert wisdom hereIf you took a break after the previous step, heat your hot end to 195°C for PLA or 220°C for ABS and allow it to come up to temperature and stabilize for a few minutes.

Image 1

No previous image

Added